Compression garments come in different compression classes, ranges, or levels. This description differs between regions or countries. In Germany, for example, the so-called RAL-GZG standard is dividing compression garments into four different compression classes from mild to very strong compression or class I-IV. The exact pressure of each compression garment is usually specified in millimeters of mercury (mmHg) and varies according to medical necessity.

It is not always useful to assign a specific compression class to a certain condition, therefore Healthcare Professionals will make individual decisions on the suitability of a certain compression level for each patient. This is usually based on the clinical condition itself, the patient’s tolerability for compression, additional conditions, and further individual needs.

To apply the JOBST UlcerCare Liner:

1. Gather the Compression Liner in both hands, so that the toes can easily reach the end of the liner.


2. Pull the Compression Liner onto the foot, aligning the heel of the Liner with the heel of the foot.


3. Gently pull the Compression Liner up the leg, taking special care to ease it over wound dressing.


4. Pull it upwards to the knee. Do not roll down or fold the top of the stocking.


5. Smooth any wrinkles and adjust the heel and toe of the Compression Liner for comfort.

To apply the JOBST UlcerCare Medical Compression Stocking (without zipper):

1. Apply the Compression Liner as instructed above.


2. Starting with the garment inside out, tuck the foot portion inside up to the heel and hold it with both hands, seam facing down.


3. Stretch your garment as wide as possible and pull it onto your foot in one motion. Place the heel pocket over the back of your heel.


4. Take hold of the fabric just past your toes always at the sides, never the seams.


5. Pull it up over your foot past the ankle. It should now be right side out.


6. Adjust the garment so that the heel is in place. Adjust the toe area for comfort by pulling your garment toward your toes and releasing it.


7. Now work it all the way to the knee about 2" (5cm) at a time, smoothing the creases as you go.


8. Adjust any wrinkles or uncomfortable spots by gently pulling the fabric until the pressure is even.

To apply the JOBST UlcerCare Medical Compression Stocking (with zipper):

1. Open the zipper completely.


2. Apply the Compression Liner as instructed above.


3. Point your toes and slip your foot into the foot area.


4. Place your thumb between the zipper and your leg to protect your skin.


5. Zip it closed, keeping the elastic backing between your skin and the zipper.


6. Adjust any wrinkles or uncomfortable spots by gently pulling the fabric until the pressure is even.

To care for JOBST UlcerCare liner:

The JOBST UlcerCare Liner can be machine washed in warm water (up to 60°C) with mild detergent. Do not use laundry additives such as fabric softener, optical brightener or stain remover. Rinse well. Do not wring. Do not dry the compression stockings on a radiator or in direct sunlight. Do not use bleach, dry clean or iron. Flat drying only.

To care for JOBST UlcerCare compression stocking (with and without zipper):

The JOBST UlcerCare Compression Stocking can be machine washed in warm water (up to 40°C) with mild detergent. Do not use laundry additives such as fabric softener, optical brightener or stain remover. Rinse well.Do not wring. Do not dry the compression stockings on a radiator or in direct sunlight. Tumble dry on low heat. Do not use bleach, dry clean or iron.